I have good and some bad news. The good is that I'm happy to finally say that all orders have been successfully fulfilled.
The bad is that I just really don't know when I will be able to reopen. I just started a brand new job and the transition has been rough and remain so for a bit. There's mention of a move, too. Its going to take a bit before I'm ready.
Bottom line is that I just didn't make enough money from this, and I'm greatly uncomfortable with the idea of raising prices. I want to be there for the fandoms/communities, but I need to focus on myself before setting this back up.
Store Sections
NOTE: This item is made-to-order and NOT in stock and ready-to-ship. Item will take 1-2 weeks to complete and ship out.
3D printed accessories for finishing off Mega Drive's cosplay from Sega Hard Girls and Superdimension Neptune Vs Sega Hard Girls.
Sold as set or individual pieces.
-Glasses are just decoration, no lenses come with it.
-Controller hair piece measures a little under 4in (96mm) long and attaches with a heavy duty hair clip.
-Controller sleeve pieces measure a little under 4in (96mm) long and easily attaches with magnets.
-16-Bit badge is available in both large and small. Large measures about 3.5in (93mm) tall and 3in (75mm) wide. Small measures about 2.5in (63mm) tall and 2in (50mm) wide. Both attach via magnets. Please write in order comments the size. If not comments, I'll send the large size.
-"Start buttons" buttons. Comes with 5 larger ones for the jacket, and 6 smaller ones for the button up shirt. I'm including enough for a full, normal sized button up shirt. Large ones are about 1.5in (40mm) x 0.5 (16mm), and small ones are about 1in (25mm) x 0.5in (10mm). Attach using fabric embellishing glue.
Important notes:
-Please see pictures of examples of how I attached everything.
-When attaching parts with magnet backs, don't drop a magnet into place, it may break, instead slide the magnet into position.
-When washing a shirt with 3D printed parts permanently attached, only wash it in a cold load and hang dry.
-Magnets used a neocadyum "rare earth" magnets. They are powerful, so take care not to put them too close to cell phones or hotel room keys. Not sure "how close" to a cell phone is close enough for a magnet to damage it, but I went all day wearing my cosplay and not damaging my phone and was on it a lot. So just be aware of it. I am not to be held responsible for any damaged phones.
-Nothing in the photos, sans the 3D printed items themselves, are included. That includes wig, jacket, button up shirt, example glue, etc
Items are printed with PLA, please be aware that they might deform in an hot car or on a hot day for too long. I am not held responsible for this.
